Waveform Analysis - Rigol 2000 Series User Manual

RIGOL

Waveform Analysis

This function is used to analyze the recorded waveform. Press Utility Record 
Mode and use
point, the screen is divided into two display areas as shown in the figure below.
Settings and Results
Please refer to the following explanations to set the waveform analysis parameters.
1. Analyze
Press Analyze to select the desired analysis mode.
Trace: perform analysis on the basis of the templet selected by users. For

the detailed information, refer to "Analysis Based on Trace".
Pass/Fail: perform analysis on the basis of the Pass/Fail mask created by

users. For the detailed information, refer to "Analysis Based on
Pass/Fail Mask".
2. Source
Press Source to select the channel (CH1 or CH2) to be analyzed.
Note:
Only channels currently enabled can be selected.
11-8
to select "Analyze" to open the waveform analysis menu. At this
Templet Display Current Frame
Figure 11-3 Waveform Analysis
Chapter 11 Waveform Record
MSO2000A/DS2000A User Guide