Pass/Fail Test
14
Pass/Fail Test
During the product design and manufacturing process, you usually need to monitor
the variations of the signal or judge whether the product is up to standard. The pass/
fail test function of this series oscilloscope can accomplish this task perfectly. It
compares the signal under test with "standard" waveforms and display the test results
based on user-defined test rules. When the pass/fail status is detected, you can
choose to stop monitoring, sound an alarm with the beeper, or save the current
screen image.
Click or tap the function navigation icon
open the function navigation. Then click or tap the Pass/Fail button to enter the
"PassFail" setting menu. You can also press the front-panel
Fail to enter the "PassFail" setting menu. The menu is as shown in the figure below.
14.1
To Enable or Disable the Pass/Fail Test Function
In the "Pass/Fail" setting menu, click or tap the Enable on/off switch to enable or
disable the pass/fail test function.
You can select the source, create mask, and set test result output only after the pass/
fail test function is enabled.
HDO4000 User Guide
186
at the lower-left corner of the screen to
Figure 14.1 Pass/Fail Test Menu
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
key and select Pass/