Scanning Does Not Start - Ricoh fi-8040 Operator's Manual

Scanning Does Not Start

Check the following points
● Did you configure the settings for the button on the touch screen to be used for starting a
scan? (page 225)
● Is the document loaded in the ADF paper chute (feeder) correctly? (page 225)
Is the ADF closed properly? (page 225)
●
Are the scanner and the computer properly connected? (page 225)
●
● Have WinHTTP proxy settings been configured on the computer? (page 226)
If the problem still persists, check each item in
Provider (page 248)
product. Refer to the contact information in the Contact List if supplied with this product, or
refer to the contact information in the Contact for Inquiries section if provided in Safety
Precautions supplied with this product, and then make an inquiry.
●
Did you configure the settings for the button on the touch screen to be used for starting a scan?
Solution
Configure the settings for the button on the touch screen to be used for starting a scan.
For details, refer to
Using the Scanner Connected to a Computer) (page
●
Is the document loaded in the ADF paper chute (feeder) correctly?
Solution
Reload the document in the ADF paper chute (feeder).
●
Is the ADF closed properly?
Solution
Close the ADF firmly.
If the document is caught in the ADF, remove the document and close the ADF.
●
Are the scanner and the computer properly connected?
Solution
● For a wired LAN
Connect the scanner and the computer via a wired LAN. When you cannot connect them via
a wired LAN, refer to
202).
● For USB
Connect the USB cable properly. For details, refer to
Computer via a USB Cable (page
first, then contact the distributor/dealer where you purchased this
Using an Image Scanning Application Started on the Touch Screen (When
Cannot Connect the Scanner and a Computer via a Wired LAN (page
45).
225
Before You Contact the Scanner Service
74).
Using the Scanner Connected to a
Troubleshooting