Network - Ricoh fi-8040 Operator's Manual

Network

● Wired LAN (page 277)
● How to connect from a browser (page 279)
DirectScan (page 279)
●
Server (page 283)
●
Network Encryption (page 286)
●
● Check connection (Ping) (page 287)
Wired LAN
Configure the settings for wired LAN.
Enable Wired LAN
Enable
Specify whether or not to use the scanner connected to a wired LAN.
The factory default setting is set to on.
When [Enable] is set to off, the scanner cannot be connected to a network, even if the
scanner is connected to a wired LAN.
Set this option to off when you use the scanner only via the USB connection for the
following purposes:
● To reduce power consumption
● To enhance security
● To use [Enable USB Power]
For details, refer to
If this setting is changed, the scanner is restarted.
IP address (IPv4)
Obtain IP Address
Set an IPv4 address of the scanner.
● Obtain automatically (DHCP)
This is the factory default setting.
● Configure manually
When [Configure manually] is selected, specify the following items:
- IP Address
- Subnet Mask
- Default Gateway
Power Management (page
277
Scanner Settings (Touch Screen)
273).