Ricoh fi-8040 Operator's Manual page 391

- Both Sides
● Barcode Detection Target
Set the target page in the document to detect barcodes on.
- All sheets
- First sheet only
This is the factory default setting.
● Barcodes per page
Specify the maximum number of barcodes to be detected per page from 1 to 20.
Note that the bigger the maximum number is, the longer it takes for scanning.
The factory default setting is [1].
Output
File Format
Set a file format of images.
● JPEG
● PDF
This is the factory default setting.
● SinglePage PDF File
ATTENTION
[JPEG] can not be specified when [Black & White] is selected for [Image Mode].
When [JPEG] is selected, specify the following item:
● JPEG Compression
Adjust the data size of a JPEG image.
- Large
The file size is smaller but the image quality is lower than documents scanned
using the [Medium] setting.
- Medium
This is the factory default setting.
- Small
The image quality is higher but the file size is larger than documents scanned
using the [Medium] setting.
Scanning speed may also be reduced.
File Name
Set a file name format for images.
Add {Serial Number} to the beginning
The following string is added to the beginning of file names:
fi- ScannerSerialNumber
Network Settings (fi Series Network Settings)
391