Ricoh fi-8040 Operator's Manual page 297

Outputs the image without filling in the specified area with the background color from
the bottom edge of the image towards the outside. (Outputs the image with the
specified area added when [Page End Detection] is set in the scanner driver.)
● This setting can also be configured in the scanner driver.
In such a case, the page edge filler of the scanner driver is used on the image which the
scanner already filled in the edges.
Dropout Color
You can exclude a color from being scanned by selecting either red, green, or blue (three
primary colors).
For example, when scanning a document with black characters and a green frame, if you select
green for the dropout color, only the black characters of the document are scanned.
To scan documents without excluding any colors, set to [None].
● Red
● Green
This is the factory default setting.
● Blue
● None
ATTENTION
● If the specified color on the document is too dark, it may not be excluded.
● You cannot specify a color other than Red, Green, and Blue.
To drop out other colors, configure the setting in the scanner driver.
For details, refer to the help for the scanner driver.
HINT
● This is only available in black & white or grayscale mode.
● This setting can also be configured in the scanner driver.
Note that priority is given to the scanner driver setting.
Offset
Specify a starting position for scanning.
The specified value can range from -2 to +2 mm (in increments of 0.5).
The factory default setting is "0".
Main-scan ADF front (mm)
Specify the horizontal position (widthways) for the ADF front.
Sub-scan ADF front (mm)
Specify the vertical position (lengthways) at the top of the page for the ADF front.
297
Scanner Settings (Touch Screen)