Ricoh fi-8040 Operator's Manual page 111

For details, refer to How to Load Documents (page
3
Press the feed mode button on the touch screen to switch the button display to the [Manual -
Single] button.
Every time you press the button, it switches to the other type.
ATTENTION
The scanning speed slows down when the feed mode is switched to Manual Single Mode.
HINT
The setting for switching the feed mode to Manual Single Mode can also be configured in the
scanner driver. Note that priority is given to the scanner driver setting.
For details, refer to the help for the scanner driver.
4
Scan the document with the image scanning application.
For details, refer to the manual/help of the image scanning application.
ATTENTION
Manual Single Mode is the mode for scanning a document folded in half or a multi-layered
document such as an envelope.
Therefore, even if the setting for detecting overlapped documents is enabled, such documents
are not detected as overlapped documents.
HINT
● In Manual Single Mode, the scanner will wait for documents to be loaded in the ADF paper
chute (feeder) until the timeout time elapses after scanning is started or a document is
ejected.
To end a scan before the timeout time elapses, press the [Pause] button.
Scanning will finish if no document is loaded within the timeout time.
You can set a timeout time as follows.
88).
111
Various Ways to Scan