Adding/Changing/Deleting A Job; Adding A Job - Ricoh fi-8040 Operator's Manual

Adding/Changing/Deleting a Job

ATTENTION
When a password for editing DirectScan settings has been set, the password is required to set save
destinations, email addresses, and jobs.
Set a password to prevent save destination paths or email addresses from being leaked.
Change the password regularly.
The password for editing DirectScan settings can be changed in the screen that appears in the
following procedure:
→ [Scanner Settings] → [Network] → [DirectScan] → [Password for Editing DirectScan
Settings]
HINT
Jobs can be configured in fi Series Network Settings.
For details, refer to Network Settings (fi Series Network Settings) (page

Adding a Job

You can register jobs to be processed for DirectScan.
You can register the way to send images from a scanner (saving them to a folder or sending them by
email) and the scan settings as a job, according to the intended use of images.
Up to 25 jobs can be added.
1
In the main screen, press the [Perform Job] button.
2
In the [Select Job] screen, press
3
In the [Edit Job] screen, press
HINT
When you select a job and press
4
In the [Add Job] screen, configure the settings and press the [Set] button.
For details about the [Add Job] screen, refer to
The job is added to the [Edit Job] screen.
5
In the [Edit Job] screen, press
.
.
or , the job moves up or down by one.
Add Job/Change Job (page
.
146
Various Ways to Scan (DirectScan)
359).
258).