Ricoh fi-8040 Operator's Manual page 420

Code Character Set
- For barcodes that
begin with <FNC1>
(EAN128)
The first FNC1 will not
be output. Barcode
values will be output
with function codes
other than FNC1
replaced with "_"
(underscore).
- For barcodes that do
not begin with <FNC1>
<FNC1> to <FNC4> are
not output.
● Start/Stop characters
(CODE-A, CODE-B,
CODE-C)
● Code set characters
(CODE-A, CODE-B,
CODE-C)
Codabar
● Start/Stop characters
(NW-7)
(ABCD)
● Numeric character (0-9)
● Symbols (-$/.+:)
ITF Numeric character (0-9)
*1:When scanning barcodes containing more than 32 digits, make sure that the barcode has been
accurately recognized before starting operations.
●
Detection Conditions for One-dimensional Barcodes
Item Condition
Barcode height 10 to 30 mm/0.39 to 1.18 in.
Barcode width 300 mm/11.81 in. or less
Barcode margin 5 mm/0.20 in. or more on each side of barcode
(The left and right edges of ITF are either 5 mm/0.20 in. or more, or six times
the width of the thin element or more, whichever is larger)
Check Digit
The barcode value
including the check digit
will be output without
check digit verification.
The barcode value
including the check digit
will be output without
check digit verification.
420
Appendix
Field Width
1 to 32 (excludes start and
stop codes) (*1)
2 to 32 (always an even
number of digits) (*1)