Scanner Settings (Software Operation Panel); Starting Up The Software Operation Panel - Ricoh fi-8040 Operator's Manual

Scanner Settings (Software Operation
Panel)
This section explains how to use the Software Operation Panel to configure the scanner settings.
The Software Operation Panel can be used when using the scanner connected to a computer.
HINT
The scanner settings can also be configured from the touch screen. For details, refer to
Settings (Touch Screen) (page
With the Software Operation Panel, you can configure settings for operations of the scanner and
management of the consumable parts.

Starting Up the Software Operation Panel

Start up the Software Operation Panel in the following procedure.
ATTENTION
● Do not start up the Software Operation Panel in the following situations:
- During scanning
- During configuring settings on the touch screen
● If you change the Software Operation Panel settings while the scanner driver window is displayed,
the changes may not be applied immediately. In that case, close the scanner driver window and
open it again.
HINT
When the scanner is connected via a wired LAN and selected with Scanner Selection Tool, you can
start up the Software Operation Panel from a computer.
1
Make sure that the setup process for the scanner is complete, then turn on the scanner.
For details about how to setup the scanner, refer to
For details about how to turn on the scanner, refer to
2
Display the [Software Operation Panel] window.
● For Windows Server 2012
Right-click the Start screen, and select [All apps] on the app bar → [Software Operation Panel]
under [fi Series].
● For Windows Server 2012 R2
Click [↓] on the Start screen and select [Software Operation Panel] under [fi Series].
To display [↓], move the mouse cursor.
● For Windows 10/Windows Server 2016/Windows Server 2019/Windows Server 2022
Click [Start] menu → [fi Series] → [Software Operation Panel].
269).
303
Scanner Setup (page 40).
How to Turn the Power ON (page
Scanner
61).