Settings To Use The Scanner Only Via The Usb Connection [Network Function] - Ricoh fi-8040 Operator's Manual

Settings to Use the Scanner Only via the USB Connection [Network
Function]
Specify whether or not to use the scanner only via the USB connection.
Disable the wired LAN connection if you want to use the scanner only via a USB connection for the
following reasons.
● To reduce power consumption
● To enhance security
● To use Enable USB power feeding
For details, refer to Method for Turning the Scanner ON/OFF [Power Switch Control] (page
If this setting is changed, the scanner is restarted.
1
Start up the Software Operation Panel.
Refer to Starting Up the Software Operation Panel (page
2
From the list on the left, select [Device Setting 2] → [Network Function].
3
Select [Disable] to use the scanner only via a USB connection.
The factory default setting is [Enable].
HINT
● If [Enable] is selected for [Network Function], you can use the scanner either via a USB
connection or a wired LAN connection.
● [Network Function] appears when the scanner is connected via USB cable.
Scanner Settings (Software Operation Panel)
303).
353
354).