Ricoh fi-8040 Operator's Manual page 378

ATTENTION
Note that an IPv6 address is not supported.
HINT
When entering a host name, the DNS servers need to be set on the scanner.
- Port Number
Depending on the setting for [Encryption], the initial value changes as follows:
● When [Encryption] is [Explicit Encryption (Explicit Mode)], the initial value is "21".
● When [Encryption] is [Implicit Encryption (Implicit Mode)], the initial value is "990".
The factory default setting is "21".
- Encryption
Set the encryption method for communications used when connecting to the FTPS server.
● Explicit Encryption (Explicit Mode)
This is the factory default setting.
● Implicit Encryption (Implicit Mode)
- Validate server certificates
Set whether to validate server certificates using CA certificates registered on the scanner.
For details about CA certificates, refer to
The check box is cleared for the factory default setting.
- Save Destination Path
The spaces before and after the character string and "/" prefix are ignored.
" " will be replaced with "/". When the first character is " ", the character will be replaced
with "/" and the leading "/" will be deleted.
HINT
If the save destination path contains characters that cannot be displayed on the touch
screen of the scanner (such as environment-dependent characters), the path may not
display correctly on the screen.
- Username
Set the user name used to connect to the save destination.
You can also set the name in the "UserName@Domain" or "Domain UserName" format.
The space before or after the character string is ignored.
HINT
If the user name contains characters that cannot be displayed on the touch screen of the
scanner (such as environment-dependent characters), the name may not display correctly
on the screen.
Network Settings (fi Series Network Settings)
CA Certificates (page
378
373).