Cleaning The Carrier Sheet - Ricoh fi-8040 Operator's Manual

Cleaning the Carrier Sheet

The Carrier Sheet should be cleaned with either a piece of dry cloth, a cloth moistened with
Cleaner F1/mild detergent, or a sheet of Cleaning Wipe.
Gently wipe dirt and dust off the surface and the inside of the Carrier Sheet.
As you keep using the Carrier Sheet, dirt and dust will accumulate on the surface and the inside.
Clean it regularly because it may cause problems related to scanning or affect the scanned results.
ATTENTION
● Make sure that the Carrier Sheet is not creased.
● To avoid deformation and discoloration, never use paint thinner or any other organic solvents.
● Do not use force to rub against the Carrier Sheet because it may be damaged or deformed.
● After cleaning the inside of the Carrier Sheet with a cloth moistened with Cleaner F1/mild
detergent or a sheet of Cleaning Wipe, do not close the Carrier Sheet until it is completely dry.
● The Carrier Sheet should be replaced approximately every 500 scans.
Note that these guidelines vary depending on the type of documents scanned and how often
the scanner is used and cleaned.
For information on purchasing the Carrier Sheets, contact the distributor/dealer where you
purchased this product. Refer to the contact information in the Contact List if supplied with
this product, or refer to the contact information in the Contact for Inquiries section if provided
in Safety Precautions supplied with this product, and then make an inquiry.
165
Daily Care