Configuring The Scan Setting To Drop Out Specified Colors When Scanning [Dropout Color] - Ricoh fi-8040 Operator's Manual

Configuring the Scan Setting to Drop Out Specified Colors When Scanning
[Dropout Color]
You can exclude a color from being scanned by selecting either red, green, or blue (three primary
colors).
For example, when scanning a document with black characters and a green frame, if you select green
for the dropout color, only the black characters of the document are scanned.
To scan documents without excluding any colors, set to [None].
1
Start up the Software Operation Panel.
For details, refer to
2
From the list, select [Device Setting 2] → [Dropout Color].
3
Select a color that you want to remove.
Red, Green, Blue
The selected color is removed.
The factory default setting is [Green].
None
No color is removed.
ATTENTION
● If the specified color on the document is too dark, it may not be excluded.
● You cannot specify a color other than Red, Green, and Blue.
To drop out other colors, configure the setting in the scanner driver.
For details, refer to the help for the scanner driver.
HINT
● This is only available in black & white or grayscale mode.
● This setting can also be configured in the scanner driver.
Note that priority is given to the scanner driver setting.
Starting Up the Software Operation Panel (page
333
Scanner Settings (Software Operation Panel)
303).