Ricoh fi-8040 Operator's Manual page 94

Image scanner
Table of Contents

Advertisement

● Make sure you use a card that meets the following specifications, and check if the card can be
fed before scanning it.
- Type: Compliant with the ISO7810 ID-1 type
- Size: 85.6 × 53.98 mm/3.37 × 2.13 in.
- Thickness: 0.76 mm or less (Embossed cards allowed)
- Material: PVC (polyvinyl chloride) or PVCA (polyvinyl chloride acetate)
● Load one plastic card at a time in the ADF paper chute (feeder).
● It is recommended to place the card face-down in the ADF paper chute (feeder).
● When you scan an embossed card, it is recommended that the card should be loaded face-down
in the ADF paper chute horizontally.
● Rigid cards may not be fed properly.
● If there is dirt on the surface of the card, such as grease marks (fingerprints), perform scanning
after wiping the dirt off.
● Scanning a thick document such as a plastic card will always be falsely detected as overlapped
documents.
In that case, specify one of the following settings and try scanning again.
- Use the intelligent multifeed detection function.
- Disable the setting to detect overlapped documents by the ultrasonic sensor.
- Scan with Manual Single Mode.
94
How to Load Documents

Hide quick links:

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents