Table of Contents
Advertisement
44
Configure Modules in RSLogix 5000 Software
Use the Module Properties
and General Dialogs
Publication 1791DS-UM001H-EN-P - April 2009
To use the Module Properties and General dialogs to configure a
safety module, follow this procedure.
1. From the I/O configuration tree, double-click the safety module,
such as the 1791DS-IB12 module, to see the Module Properties
dialog.
2. From the Module Properties dialog, complete entries for the
General dialog.
A. For Name, type a unique name.
B. For Node, select the DeviceNet Node number, noting this
number and the switches on the actual modules must match.
C. For Description, if desired, type a description.
For a detailed explanation of the safety network number (SNN),
see the GuardLogix Controller Systems Safety Reference Manual,
publication 1756-RM093, noting that in most cases, you use the
default provided by the RSLogix 5000 software.
Read the following for an overview explanation of why the
safety network number exists for DeviceNet safety.
The purpose of a SNN is to make sure that every module in a
system can be uniquely identified.
Advertisement
Table of Contents
