Table of Contents
Advertisement
1732DS-IB8XOBV4 module is shown.
1732DS-IB8 modules have identical dimensions.
Connect I/O Power and I/O
Cables
Vertical Module Installation (not including 1791DS-IB12, 1791DS-IB8XOB8, and
1791DS-IB4XOW4 modules)
Use horizontal or vertical mounting.
See the table for a list of applicable wires that fit the I/O connector
when using recommended post-crimp terminals.
Wire Type and Size
Wire Type
Solid wire
Stranded wire
Use ferrules with plastic insulating collars conforming to
DIN46228-4. Note that a ferrule with similar appearance but not
conforming to the standard may not match the terminal block of the
module. Confirm wire dimensions, noting that wire dimensions shown
in the figure are rough dimensions.
Use wires of the same diameter for any two-wire ferrules
IMPORTANT
that are used.
Install and Connect Your Modules
35 mm (1.38 in.) DIN Rail
End Plate
1791DS-IB8XOBV4 module is shown.
1791DS-IB16 modules have identical dimensions.
Wire Size
2
0.2...2.5 mm
(AWG 24...12)
2
0.34...1.5 mm
(AWG 22...16)
Publication 1791DS-UM001H-EN-P - April 2009
37
End Plate
44225
Advertisement
Table of Contents
