Rockwell Automation 1732DS-IB8 User Manual page 71

7. From the Configure SmartGuard USB Device dialog, click OK to
see the Configure Drivers dialog, noting that the SmartGuard
driver should be running.
8. From the Configure Drivers dialog, click close.
9. Follow the procedure for working with RSNetworx for
DeviceNet software.
Work with RSNetworx for DeviceNet Software
Use this procedure to work with RSNetworx for DeviceNet software.
1. Before you begin to design a project with RSNetworx for
DeviceNet software, follow these procedures.
a. Load the proper electronic data sheet (EDS) files using the
EDS Hardware Installation Tool. For all products, as needed,
for your project, if using the following for the first time, find
the EDS files at http://www.rockwellautomation.com/:
1791DS Guard I/O modules
1732DS Guard I/O modules
1752 SmartGuard controller
b. From RSLinx software, open RSWho and select the
SmartGuard driver, noting that it browses the DeviceNet
network connected to the SmartGuard.
Configure Modules in RSNetWorx for DeviceNet Software
Publication 1791DS-UM001H-EN-P - April 2009
67