Table of Contents
Advertisement
Configuring General
Module Features
Inhibit the connection to the module
If you want a Major Fault on the Controller to
occur if there is connection failure with the I/O
module while in Run mode, click here
This Fault box is empty when you are offline. If
a fault occurs while the module is online, the
type of fault will be displayed here
Set the Servo Update Period – The correct
servo update period is based on the
transducer lengths and the number of
recirculations on each axis associated with
the module. The Feedback tab, described on
page 58, has a utility that calculates the
minimum update period.
For more information on the Associated
Axes, see the Configuring the Axes Features
beginning on page 36.
Publication 1756-UM525A-EN-P - June 2003
You see the series of wizard screens after the naming screen. Use these screens
to configure general features on the 1756-HYD02 module.
Configuring the 1756-HYD02 Module
Click here to move to the next page
Chapter 3
35
Advertisement
Table of Contents
