Table of Contents
Advertisement
Safety Output Parameters
Parameter Name
x
Output Point Mode
x
Output Point Operation
Type
Allocate Remote I/O
Value
Description
Not Used
An external output devices is not connected.
Safety
When the output is ON, the test pulse is not output (remains
ON).
Safety Pulse Test
Using this function, short-circuits between output signal lines
and the power supply (positive side) and short-circuits between
output signal lines can be detected.
Single Channel
Use as single channel.
Dual-channel
Use as dual-channel. When both channels are normal (OK),
outputs can be turned ON.
Concerning I/O allocations, the module internally stores I/O data. To
set connection paths, use RSLogix 5000 or RSNetWorx for DeviceNet
software to allocate I/O data for the master unit. No settings are made
by default. Be sure to set the required connection paths.
Concerning I/O data, the module stores the following data:
• SAFETY: Information the controller can use in safety-related
functions
• STANDARD: Additional information that must not be relied on
for safety functions
Configuration Reference Information
Default
Not Used
Dual-channel
Publication 1791DS-UM001H-EN-P - April 2009
121
Advertisement
Table of Contents
