Placing A Test Call - Polycom VSX Series Administrator's Manual

Administrator's Guide for the VSX Series

Placing a Test Call

3 - 26
2. Configure these settings:
Setting
Always Dial Area
Code
Dial 1+ for all USA
calls
When you finish configuring the system, you can use one of the sample numbers
in the directory to test your setup.
To place a test call:
1. On the Place a Call screen, select
2. Select Category.
3. Select Sample Sites and highlight a location.
4. Press Call on the remote control.
You can also find a list of worldwide numbers that you can use to test your VSX system at
www.polycom.com/videotest.
If you have trouble making video calls:
❑
Make sure the number you dialed is correct, then try the call again. For
example, you may need to dial 9 for an outside line or include a long distance
access code or country code.
❑
To find out if the problem exists in your system, ask the person you were trying
to reach to call you instead.
❑
Find out if the system you are calling has its power turned on and is
functioning properly.
❑
If you can make calls but not receive them, make sure that your system is
configured with the correct number.
Description
Specifies that calls to sites in the same area code must include
the area code.
Specifies that calls to systems in the United States must include
a "1" before the area code.
Directory.
www.polycom.com/videodocumentation