Polycom VSX Series Administrator's Manual page 44

Administrator's Guide for the VSX Series
Connecting a Projector
2 - 20
If you have a VSX room system, you can connect a projector to display
presentation materials from a computer.
To connect a projector to a VSX room system:
For this
system... Do this
VSX 6000 1. Connect the additional display adapter cable option to the VGA output
on the rear panel of the system. The adapter allows you to connect a
VSX 7000
VGA, S-video, or composite video cable.
2. Connect the projector to the additional display adapter cable using the
appropriate cable.
Note: You cannot connect a VGA monitor directly to the system if you
have already installed a second monitor or a projector. Only one
connector on the additional display adapter can be active at any given
time.
You can connect a projector directly to the Visual Concert VSX unit's
VGA output, instead of using the system's additional display adapter.
VSX 8000 Connect the projector to the system's VGA output using a VGA cable.
After you have finished setting up the system, you will need to configure the projector's
behavior. Refer to Configuring Content Display on page 4-9.
www.polycom.com/videodocumentation