Polycom VSX Series Administrator's Manual page 42

Administrator's Guide for the VSX Series
Connecting a VCR/DVD Player
Composite
video cable
Composite to
S-Video adapter
2 - 18
To connect an additional monitor to a VSX room system:
For this
system... Do this
VSX 6000 1. Connect the additional display adapter cable option to the VGA output
on the rear panel of the VSX system. The adapter allows you to
VSX 7000
connect a VGA, S-video, or composite video cable.
2. Connect the monitor to the additional display adapter cable using the
appropriate cable.
Note: You cannot connect a second television monitor directly to the
system if you have already installed a VGA monitor or a projector. Only
one connector on the additional display adapter can be active at any
given time.
VSX 8000 Connect the monitor to the system's monitor 2 output using an S-video
cable,
or
Connect the VGA monitor to the system's VGA output using a VGA
cable.
After you have finished setting up the system, you will need to configure the monitor's
behavior. Refer to Configuring Monitors on page 4-6
page 4-9.
You can connect a VCR or DVD to play material during a call. If you have a
VSX 7000 or VSX 8000 system, you can also connect a VCR or DVD to record your
video conference.
To set up a VCR or DVD to play:
1. Place the VCR or DVD in a location that is easily accessible to call participants.
2. Connect the yellow, red, and white connectors of the composite video cable to
the outputs on the VCR or DVD player.
Connect the other ends of the cable to the VCR inputs on the rear panel of the
3.
system.
and Configuring Content Display on
www.polycom.com/videodocumentation