Polycom VSX Series Administrator's Manual page 100

Administrator's Guide for the VSX Series
Configuring Content Display with People+Content IP
4 - 10
People+Content IP is an optional software application available for VSX systems.
It enables a presenter to show content from a computer to other sites in a video
conference using only an IP network connection.
The presenter can show PowerPoint® slides, video clips, spreadsheets, or any
other type of content that runs on a computer. Supported resolutions include CIF,
SIF, 4CIF, 4SIF, VGA, SVGA, and XGA.
Before a presenter can use a computer to show content with People+Content IP,
you need to:
❑
Enable People+Content IP on the VSX system.
When you purchase this option, you receive a software activation key. This key
allows you to enable People+Content IP on a VSX system.
❑
Install the People+Content IP software application on the computer(s) that the
presenter will use to show content.
You don't need to change the computer resolutions and you don't need special
cables or hardware, but the computer(s) must meet these requirements:
• Operating System: Windows 2000, Windows XP Home, or Windows XP
Professional
• Minimum computer: 500 MHz Pentium® III (or equivalent); 256 MB
memory
Recommended computer: 1 GHz Pentium III (or equivalent); 500 MB
memory
Note that, although you use the license key on only one VSX system, you can
install the presenter software on an unlimited number of computers.
❑
Connect the computer(s) to the IP network.
For information about purchasing the People+Content IP option, please contact your
Polycom distributor.
To enable People+Content IP on a VSX system:
On a computer, open a web browser and go to the Polycom Resource Center
1.
Video Downloads page at http://extranet.polycom.com.
2. Enter the license number you received when you purchased the
People+Content IP option.
3. Enter the serial number of the VSX system onto which you want to install
People+Content IP.
www.polycom.com/videodocumentation