Placing A Test Call - Polycom VSX 7000 Administrator's Manual

VSX 7000 Series Administrator's Guide

Placing a Test Call

48
When you finish configuring the system, you can use one of the sample numbers
in the Directory to test your setup.
To place a test call:
1. On the Place a Call screen, select
2. Select Category.
3. Select Sample Sites and highlight a location.
4. Press on the remote control.
You can also find a list of worldwide numbers that you can use to test your VSX system at
www.polycom.com/videotest.
If you have trouble making video calls:
Make sure the number you dialed is correct, then try the call again. For
example, you may need to dial 9 for an outside line or include a long distance
access code or country code.
To find out if the problem exists in your system, ask the person you were trying
to reach to call you instead.
Find out if the system you are calling has its power turned on and is
functioning properly.
If you can make calls but not receive them, make sure that your system is
configured with the correct number.
.
www.polycom.com/videodocumentation