Polycom VSX Series Administrator's Manual page 96

Administrator's Guide for the VSX Series
Configuring Monitors
4 - 6
The VSX system allows you to customize displays to suit your room and
equipment configuration, including choosing the monitor for presenting content.
To configure monitors:
1. Do one of the following:
• VSX room systems
Go to System > Admin Settings > Monitors > Monitors.
• VSX 3000
Go to System > Admin Settings > Monitor.
2. Configure these settings:
Setting Description
Monitor 1 Specifies the monitor's aspect ratio and format:
•
VSX 6000
VSX 7000
•
VSX 8000
•
•
•
You can set a wide-screen monitor to 16:9 to resize the UI screens
even if you do not configure it for dual-monitor emulation. The
far-site video is displayed in the same way for both settings.
Note: If you select 16:9, you will also need to set up the monitor for
full-screen display. In the monitor's setup menu, choose the setting
that stretches the picture uniformly without clipping the edges.
Use this setting:
4:3 — Select if you are using a regular TV monitor.
16:9 — Select if you are using a wide screen monitor and
configuring for dual-monitor emulation.
S-Video — Select if the main monitor is connected to a VSX 8000
system using an S-Video cable.
Composite — Select if the main monitor is connected to a
VSX 8000 system using a composite video cable and S-Video to
RCA adapter.
VGA — Select if you are using a VGA monitor as the primary
display device for a VSX 8000. The supported resolution is SVGA
800 x 600 at 60 Hz. If this option is selected, Monitor 2 is disabled.
Not this setting:
www.polycom.com/videodocumentation