Polycom VSX Series Administrator's Manual page 109

© Polycom, Inc.
To configure systems to send and receive Polycom StereoSurround:
Go to this screen:
Audio
System > Admin Settings >
Audio
Audio Input
System > Admin Settings >
Audio > Audio Settings > Next
Audio Levels
System > Admin Settings >
Audio > Audio Settings > Next
> Next
VSX 7000
To test your stereo configuration:
Go to this screen:
Mic Placement
System > Admin Settings >
Audio > Stereo Settings > Next
Mic Identity
System > Admin Settings >
Audio > Stereo Settings
Speaker Test
System > Admin Settings >
Audio > Stereo Settings >
Next > Next
To make a test call in stereo:
>> Select Polycom Austin Stereo from the directory, or enter stereo.polycom.com
in the dialing field and press Call on the remote control.
The Polycom Austin Stereo site demonstrates the stereo feature with an
entertaining and informative presentation.
Chapter 4 - Customizing the VSX System
Configure these settings:
Enable Polycom StereoSurround.
Set Echo Canceller to Off.
Set Subwoofer Speaker to Off.
Configure these settings:
Specify the Table Style and the number of
microphones being used, and make sure the
microphones are positioned as shown.
Also refer to Positioning Microphones to Send Stereo
on page 2-23 and Connecting and Positioning a
VTX 1000 to Send Stereo on page
Gently blow on the microphones while watching the
Left and Right meter. Identify which microphone is on
the right and which is on the left, and Swap them if
necessary.
Test the speakers to check volume and verify that audio
cables are connected. If the system is in a call, the far
site hears the tone.
Exchange the right and left speaker leads if the
channels are reversed.
2-31.
4 - 19