Polycom VSX Series Administrator's Manual page 35

© Polycom, Inc.
To install the network interface module:
For this
system... Do this
VSX 7000 1. Ensure that the system is powered off.
2. Unplug the power cord.
3. Loosen the captive screws holding the cover plate in place on the
back of the subwoofer, and remove it.
4. Slide the network interface module into the opening, and press firmly
to seat the connector.
5. Tighten the captive screws to secure the network interface module in
the subwoofer.
VSX 8000 1. Ensure that the system is powered off.
2. Unplug the power cord.
3. Remove the screws holding the cover plate in place on the back of the
system, and remove it.
4. Slide the network interface module into the opening, and press firmly
to seat the connector.
5. Tighten the captive screws to secure the network interface module in
the system.
Note: If your deployment requires additional equipment such as an NT-1 device, ensure
that it is available, along with all cables required.
Chapter 2 - Setting Up Your System Hardware
2 - 11