ProFire PF3100 Product Manual page 74

Field Device Configuration Requirements
I/O Wizard > Add Inputs Tab
Refer to
configuring FARC valve and air position feedback inputs
Refer to
configuring an O
I/O Wizard > I/O Modules Tab
4-20 Output: Air Position Controlled by FARC
Name: As desired
FARC / O
FARC Enable: Enabled
All other settings: As desired
FARC / O
FARC air
Menu (Repeat for all channels)
actuator
All settings: As desired
FARC / O
Configure FARC table(s) in accordance with safety design
documentation and fuel-air ratio profiles.
FARC / O
All Settings: As per safety design documentation
FARC / O
Configure O
and O
2
Output Calibration Wizard
Ensure all outputs are calibrated prior to starting an appliance for use
in a FARC application. Refer to
I/O Wizard > Add Inputs Tab
Refer to
configuring Aux position feedback inputs if required.
I/O Wizard > I/O Modules Tab
4-20 Output: Aux Position Controlled by FARC
Channel: As desired
Name: As desired
FARC / O
Menu (Repeat for all channels)
FARC aux All settings: As desired
channel FARC / O
actuator Configure FARC table(s) in accordance with safety design
documentation and fuel-air ratio profiles.
FARC / O
All Settings: As per safety design documentation
FARC / O
Configure O
and O
2
Output Calibration Wizard
Ensure all outputs are calibrated prior to starting an appliance for use
in a FARC application. Refer to
Copyright © 2022, Profire Energy. All rights reserved.
855.PRO.FIRE | PROFIREENERGY.COM
Configurable I/O Expansion inputs
Configurable I/O Expansion inputs
sensor input if desired.
2
Trim Wizard > General Tab
2
Trim Wizard > Channels Tab > Channel Configuration
2
Trim Wizard > Channels Tab > Configure Curves Menu
2
Trim Wizard > O Trim Tab
2 2
Trim Wizard > O Trim Tab > Configure O
2 2
curve in accordance with safety design documentation
2
Trim profile.
Output Calibration Wizard
Configurable I/O Expansion inputs
Trim Wizard > Channels Tab > Channel Configuration
2
Trim Wizard > Channels Tab > Configure Curves Menu
2
Trim Wizard > O Trim Tab
2 2
Trim Wizard > O Trim Tab > Configure O
2 2
curve in accordance with safety design documentation
2
Trim profile.
Output Calibration Wizard
section for instructions on
section for instructions on
Curve Menu
2
section.
section for instructions on
Curve Menu
2
section.
PF3100 Product Manual
DOC-001149 v8.0
Connection Diagrams
Proportional Valve/Actuator
Wiring
Proportional Valve/Actuator
Wiring
74