ProFire PF3100 Product Manual page 194

Alert Name
Code
3022 PID Configuration Warning
3023 Pilot Module Comm Warning
3024 FARC System In Manual Mode
Appliance Firing Rate Input
3025
Invalid
IO Expansion Module Internal
3026
Voltage Fault
3027 O Trim at Limit
2
3028 High Measured %O
3029 Manual O
Copyright © 2022, Profire Energy. All rights reserved.
855.PRO.FIRE | PROFIREENERGY.COM
4-20 Aux Out Mode setting is set to PID, Low Fire Mode setting is enabled
and any of the following Advanced PID Config conditions exist:
* Pressing the OK button on the alert text opens a dialog that identifies the
offending card and input.
Controller has lost communication with a pilot card.
FARC Manual Mode setting is enabled.
The I/O Expansion card input configured as a Firing Rate input is not
reading a valid 4-20mA signal and Aux Out Manual Override setting is
enabled.
Internal card fault.
* Pressing the OK button on the alert text opens a dialog that identifies the
offending card and input.
The Oxygen Sensor input reading is at its configured Max or Min Setpoint
setting.
* This warning is hidden when the controller is not actively trimming O
(e.g., the controller is not in Process Control or the warmup conditions
have not been met.
The Oxygen Sensor input reading is above its configured High Setpoint
setting.
2
* This warning is hidden when the controller is not actively trimming O
(e.g., the controller is not in Process Control or the warmup conditions
have not been met.
Trim O Trim Manual Mode setting is enabled
2 2
Description
1. Cascade Primary SP Max is above Low Fire SP
2. Cascade Primary SP Max is below Process Temp SP
3. Cascade Primary SP Min is above Process Temp SP
4. Cascade Primary SP Min is below 0
5. Cascade Secondary SP Max is below Secondary SP
6. Cascade Secondary SP Min is above Secondary SP
7. Cascade Secondary SP Min is below 0
8. Cascade Primary/Secondary out of range
Contact Profire.
PF3100 Product Manual
DOC-001149 v8.0
2
2
194