FUTABA T16IZ SUPER Full Manual page 98

Sensor : Change slot
This procedure changes the slot number of one
registered sensor.
Linkage menu
in the Sensor screen to call the
setup screen shown below.
1. Connect the sensor to the T16IZ SUPER as
2. Tap "Change slot" on page 3/3 of the
<Sensor> screen.
3. Tap "Read".
4. A sensor details screen appears.
5. The current start slot is displayed. To change
a start slot, a ＋
set to a slot that cannot be allocated like the
table of all pages.）
6. Tap to the "Write".
button, tap.（Cannot be
This page is set when using multiple telemetry sensors
of the same type.
WARNING
Do not disconnect or turn transmitter
power OFF while telemetry sensor data
is being saved.
Sensor save data will be lost, resulting in
malfunction.
98