FUTABA T16IZ SUPER Full Manual page 181

Throttle curve / Throttle Hover trim
for each condition for optimum engine speed to
throttle stick movement.
menu and call the setup screen shown
below.
● Mixing curve setting
*For a description of the
curve setting method,
s e e t h e b a c k o f t h i s
manual.
Throttle hover trim
operating position
(White line)
centered around hovering. Use it along
with the normal pitch curve and adjust so
that up/down control at a constant engine
speed is easiest.
constant speed at all times, even during
operation which reduces the pitch
to loop, roll, 3D, or other purposes and the
idle up curve according to the performance.
simultaneously enter the same settings to
other functions, make the settings in the
group mode. In this case, the same setting
created by reducing the number of input points of
the corresponding points.
Currently selected condition name
WARNING
When actually starting the engine and
flying, always set the idle up condition
switch to OFF and start the engine in
the idling mode.
contents are entered to the all conditions.
When you want to set each condition
independently, make the settings after
selecting the single mode (Initial setting).
181
P o i n t c u r v e t y p e i s 9
points (initial), but for
simple use, 4~5 points
are sufficient.