FUTABA T16IZ SUPER Full Manual page 244

[Model data conversion method]
1. Attach a microSD card that contains model
data of T14SG/FX-22/T12K to the SD slot of a
T16IZ SUPER.
2. Turn on the power switch, and the Data
Converter should run.
3. The converter shows a list of model data in
the card. Select a model data that you want
to convert and push "CONVERT" → "Yes" key,
and the converter should begin converting
data.
4. If the convert succeeds, the converter will
show the following message. The converted
data are copied to the internal memory of
the T16IZ SUPER. Hence, if the T16IZ SUPER
does not have available space in its internal
memory, converts must fail.
5. The converter can accept model data
made by T14SG/FX-22/T12K with the latest
software only. If you try to convert model
data made by old version software, the
converter must fail to convert and show
the following error message. If this message
is shown, do the following procedure to
update the model data in order to avoid
this limitation.
model data should be updated to the latest format.
SUPER.
Association.
CAUTION
After finishing data copy, be sure to
perform a complete check of operation
with the model to be used.
Check well all the directions of operation
and all the operation switches.
244