FUTABA T16IZ SUPER Full Manual page 142

Elevator → Camber
be increased.
menu and call the setup screen shown
below.
● Mixing curve setting
(For a description of the
setting method, see the
description at the back
of this manual.)
Ailerons and flaps rate
adjustment
Activate the function by
tapping the [INH].
Condition group/single
mode selection (Gr. /Sngl)
The ON/OFF switch of
mixing is chosen.
(ON is displayed.)
the switch and tap the screen to call the
selection screen, and then select the switch
and set its ON direction. (Always ON at "--"
setting)
(For a description of the switch selection
method, see the description at the back of
this manual.)
[Corresponding model type]: Airplane/glider, 2 ailerons or more
Elevator → Camber
Elevator → Camber
Elevator → Camber
142
Note: Tailless wing elevator can be operated
when this mix is activated.
setting a switch. (Always ON at [--] setting)
Currently selected condition name
"--" item and tap the screen to call the
selection screen, and then select the VR. The
adjustment rate can be set.
T h e V R o p e r a t i o n m o d e c a n a l s o b e
selected.
(For a description of the curve setting
method, see the description at the back of
this manual.)
Overall adjustment by
Rate A and Rate B.
The value inside the
parentheses shows the
current rudder position.
Fine tuning VR setting
Operation mode
Adjustment rate