Data Reset - FUTABA T16IZ SUPER Full Manual

Data reset
selected portions or all of the settings saved in
Trim (All condition):
Reset the digital trim setting.
can be selected.
*The trim step amount and trim rate are not reset.
Trim (Current and Group condition):
Reset the digital trim setting.
selected.
the setup screen shown below.
1. Tap to the item you want to reset and tap
the screen.
2. Execute reset by tapping the "Yes".
CAUTION
Never engage the Data reset function
while the engine is starting or the
motor drive wiring is connected.
■ Sudden, abrupt spinning of propellers or rotors is
extremely dangerous.
Model memory setting data reset. (by item)
*The trim step amount and trim rate are not reset.
Model menu setting:
condition select.
All model setting:
Function Name:
A function name is reset.
Telemetry:
Reset the telemetry setting.
[Trim (All condition)]: Resets only the Trim (all
conditions)
[Trim(Current and Group condition)]: Resets
only the data of Trim (condition in use and all
the conditions set to group mode)
[Model menu setting]: Resets all the functions
in the model menu, except the condition
selection functions.
[All model setting]: Resets all the functions in
the linkage menu and model menu except
the frequency, model select, and model
type functions.
[Function name]: Resets only the function
name functions.
[Telemetry]: Resets only the teremetry
functions.
CAUTION
Throttle Reverse
■ Only the throttle channel (CH3) initial setting is
REV (reverse). Thoroughly check the Hi and Low
directions of the engine or motor used and be careful
that they do not suddenly run at full speed. Even
after data reset, CH3 is reversed
129
.