FUTABA T16IZ SUPER Full Manual page 32

[S.BUS Servo S.BUS Gyro ]
[Telemetry Sensor ]
*Connect the battery to the free port.
link both to your transmitter.
be connected.
degrees.
WARNING
S.BUS2 connectors
Don't connect an S.BUS servo/gyro to
S.BUS2 connector.
This monitor is used to check the CH mode of the
receiver.
Mode LED
* CH mode selection
Please use the External voltage input cable.
motor batteries.
DANGER
Don't touch wiring.
* There is a danger of receiving an electric shock.
Do not short-circuit the battery
terminals.
* A short circuit across the battery terminals may cause
Please double check your polarity (+ and
-) when hooking up your connectors.
explode.
Donʼ t connect to Extra Voltage before
turning on a receiver power supply.
32
Mode Switch