FUTABA T16IZ SUPER Full Manual page 155

Gyro
switched.
simultaneously controlled.
call the setup screen shown below.
The operation mode
(AVCS/NOR) and
sensitivity of the 3
axes Gyro/Gyro2/
Gyro3 can be set.
Tap to the [Rate] item. Adjust the rate.
sensitivity set value is directly read in both the AVCS and Normal modes.
the selection screen, and then select the switch and set its ON direction.
(For a description of the switch selection method, see the description at
the end of this manual.)
[Corresponding model type]: Airplane/glider/multicopter, general
Tapping this will change INH to either ON or OFF
and enable operation. Adjustment of the three
rates (sensitivity) and switching between Normal
and AVCS is possible.
155
*Initial setting does not assign a sensitivity channel. Use the
beforehand.
Condition group/
single mode selection
(Gr. /Sngl)
The ON/OFF switch of
gyro is chosen.
3 rate (gyro gain)
adjustment