FUTABA T16IZ SUPER Full Manual page 228

Gyro
switched.
simultaneously controlled.
call the setup screen shown below.
The operation mode
(AVCS/NOR) and
sensitivity of the 3
axes Gyro/Gyro2/
Gyro3 can be set.
Tap to the [Rate] item. Adjust the rate.
sensitivity set value is directly read in both the AVCS and Normal modes.
the selection screen, and then select the switch and set its ON direction.
(For a description of the switch selection method, see the description at
the end of this manual.)
Tapping this will change INH to either ON or OFF
and enable operation. Adjustment of the three
rates (sensitivity) and switching between Normal
and AVCS is possible.
228
*Initial setting does not assign a sensitivity channel. Use the
beforehand.
Condition group/
single mode selection
(Gr. /Sngl)
The ON/OFF switch of
gyro is chosen.
3 rate (gyro gain)
adjustment