FUTABA T16IZ SUPER Full Manual page 136

Activating functions for only the selected
conditions:
1. Tap the [Gr] button and switch to the [Sngl ]
mode.
and Sngl modes.
Using the offset mode:
1. Tap the Mode button and switch to the
Offset mode.
1. Tap the button of the mixing you want to
set. The mixing setup screen is displayed.
Activate the function.
2. Activate the function by tapping the [INH]
button.
direction switching
activated.
1. When you want to turn mixing ON/OFF by
switch, tap the [--] button to call the <Switch>
screen and then select the switch and its ON
direction.
mixing)
1. Tap the Master button to call the Function
menu and select the master channel.
2. To link this mixing with other mixing, tap the
"Link" button.
then select master channel side control.
1. Tap the Slave button to call the Function
menu and select the slave channel.
2. To link this mixing with other mixing, tap the
"Link" button.
1. To turn the trim mode ON/OFF, tap the Trim
button on the screen.
1. Tap the curve type selection button of the
curve type you want to use to display the
selection screen. Then, select the curve you
want to use.
description at the back of this manual.
1. When using the curve fine tuning function,
tap the [--] button of the Fine Tuning item to
call the <Switch> screen and then select the
lever, VR, etc. you want to use.
the description at the back of this manual.
1. When setting the servo speed, tap the speed
button. The Servo speed setup screen is
displayed.
description at the back of this manual.
starting and stopping.
136