Servo Speed - FUTABA T16IZ SUPER Full Manual

Servo speed
The Servo speed setting is used to set the servo
menu to call the setup screen shown below.
1. Tap the speed button of the channel you
want to set.
2. Use the value input buttons to adjust the

servo speed.

Sub-trim
The Sub-Trim function is used to set the servo
call the setup screen shown below.
1. Tap the trim display part of the channel you
want to adjust.
Value input buttons appears on the Sub-trim
menu screen.
Sets the speed of each servo.
channel.
3. Repeat this procedure for each channel.
To close this screen, tap the [Servo speed]
button.
Setting of neutral position of each servo.
and pushrods are hooked up. When you begin to set
their center position.
2. Use the value input buttons to adjust the sub
trim.
*See above
3. Repeat this step for each channel.
77
（First） 0 〜 27 （Slowly） （First） 0 〜 27 （Slowly）