FUTABA T16IZ SUPER Full Manual page 82

Tap the "CRSF" button to [ON]. A signal
conforming to the CRSF standard is
output from the S.BUS setting connector
(S.I/F) of the transmitter.
System type
■ FASSTest 18CH ---
■ FASSTest 12CH ---
Analog servos cannot be used with the R7208SB (R7308SB) in the FASSTest 12CH mode.
•
■ FASST MULTI ---
■ FASST 7CH --- FASST-7CH system receiver mode. Up to 7 channels can be used.
■ T-FHSS Air ---
■ S-FHSS --- S-FHSS system receiver mode. Up to 8 channels can be used.
FASSTest system receiver mode. Applicable with the telemetry sensor unit. Up
to 18 channels (linear16+ON/OFF2) can be used.
FASSTest system receiver mode. Applicable with receiver voltage display. Up to
12 channels (linear10+ON/OFF2) can be used. Telemetry Sensor cannot be used,
but the response speed is faster than that of the 18CH mode.
FASST-MULTI system receiver mode. Up to 18 channels (linear16+ON/OFF2)
can be used.
T-FHSS system receiver mode. Applicable with the telemetry sensor unit. Up to
18 channels (linear16+ON/OFF2) can be used.
*FASST MULTI/FASST 7CH cannot be selected for Europe.
*Bidirectional communication function of CRSF is not supported.
WARNING
Futaba is not responsible for damage
s u s t a i n e d b y c o m b i n a t i o n w i t h
parts other than Futaba Genuine
equipment.
82