FUTABA T16IZ SUPER Full Manual page 182

Normal Curve
The Throttle Hover trim setup screen can be called from the Throttle curve setup screen.
The Throttle Hover function trims the throttle near
conditions. Changes in rotor speed accompanying
trimming is also possible by using this function
only, switch the group mode to the single
mode (initial setting) and make the settings.
Idle-up 1 Curve
182
created by reducing the number of points on the
description at the back of this manual.
Idle-up 2 Curve
Throttle servo speed setting
(For a description of the setting method, see the
description at the back of this manual.)
Selection example: RD
Normal) can be selected.
Center mode: Maximum rate of change
n e a r c e n t e r b y c e n t e r t r i m o p e r a t i o n
(recommended)
Normal mode: Normal trim (horizontal
movement trim) operation.
When the value is made small, trim acts only
near the center.
operation direction can be set.