FUTABA T16IZ SUPER Full Manual page 80

Fail safe
The Fail safe function is used to set up positions
mode for each channel.
if the predefined control suddenly moves to a
Linkage menu
their last commanded position. To select the fail
F/S mode setting:
1. Tap the F/S button of the channel you want
to set, and set that channel to the [F/S]
mode.
2. Hold the corresponding stick, control, slider,
or other control in the position you want the
servo to move to when the fail safe function
is activated, and tap the F/S position button.
That position is displayed in percentage.
B.F/S setting:
Sets the servos' operating position when transmitter signals can no
longer be received or when the receiver battery voltage drops.
check your receiver battery.
WARNING
For safety, always set the fail safe functions.
1. Tap the [B.F/S] button of the desired channel
to set it to the B.F/S mode.
2. Hold the corresponding stick, VR, slider,
or other control in the position you want
the servo to move to when the battery fail
safe function is activated, and tap the F/S
position button. This position is displayed in
percentage.
button again.
its held position after indicating that your receiver
1. Enter the control setting screen by tapping
the Battery F/S release button. Now, you may
choose whether moving the throttle resets
the condition, or select a stick or switch to
deactivate it. To set a desired throttle release
position, move the throttle stick to the point
at which you wish the B.F/S to be released.
80