FUTABA T16IZ SUPER Full Manual page 186

Throttle mixing
or elevator operation. The method of applying
pirouetting can also be corrected.
increases the throttle side correction rate relative to
rapid stick operation can also be set.
menu and call the setup screen shown
below.
● Mixing curve setting
*For a description of the curve setting method,
see the description at the back of this manual.
displayed.)
other conditions, select the group mode.
When you want to set the selected condition
only, select the single mode (initial setting).
When [--] is set, the swash mixing function is
operated by merely selecting the condition.
When setting an [ON]/[OFF] switch, tap to
the [--] item and tap the screen to call the
selection screen and set the switch and its
ON position.
item corresponding to the mixing that needs
correction and tap the screen to call the curve setup
e n g i n e a n d c o r r e c t s s l o w i n g o f t h e
engine speed when the aileron stick was
operated. Engine racing can be adjusted
independently at the right aileron and left
aileron by Rates A and B.
<Acceleration function setting>
(Left) and (Right)
can be set.
correction rate is increased and decreased
can be set independently. When an
operation point is exceeded, acceleration
operation is performed.
186
Setting example
"CTRM" : The correction
rate maximum when
t h e t h r o t t l e s t i c k i s
centered.
"Linear" : Correction
applied for the entire
throttle range.