FUTABA T16IZ SUPER Full Manual page 143

Camber mixing
caused by camber operation can be corrected.
menu and call the setup screen
shown below.
Activate the function by
tapping the [INH].
Condition group/single
mode selection (Gr. /Sngl)
The ON/OFF switch of
mixing is chosen.
Condition delay cut
switch
Condition delay setting
Ailerons, flaps
and elevators rate
adjustment
● Mixing curve setting
(For a description of the
setting method, see the
description at the back
of this manual.)
[Corresponding model type]: Airplane/glider, 2 ailerons or more
Currently selected condition name
143
elevator servos can be adjusted by curve. When
the mixing direction is reversed by the linkage,
adjustments can be made by changing the
mixing rate polarity (+ or -).
setting a switch. (Always ON at [--] setting)
switch which can turn OFF the delay function can
be set.
can be set. (In side/Out side)
Servo speed setting
(For a description of the
setting method, see the
description at the back
of this manual.)
Overall adjustment by
Rate A and Rate B.