FUTABA T16IZ SUPER Full Manual page 135

Program. mixes
Programmable mixing may be used to correct
that the undesired tendencies can be corrected
the setup screen shown below.
After this function is
activated, the master
and slave function
names (or offset mixing)
are displayed.
Activate the function by
tapping the [INH] .
The ON/OFF switch of
prog. mixes is chosen.
Master function
(or Stick, Switch, Dial)
is chosen.
Slave function is chosen.
Servo speed setting
Program mixing which can be freely customized. Up to 10
mixings can be used for each condition. [All model types]
to the programmed channel servo operation and
may control up to four circuits simultaneously.
other programmable mixing functions. The link
individually.
Mixing/Offset mode
switch
Trim mode setting ON/OFF.
135
● Group/single mode
switch (Gr./Sngl)
(For more information,
see the description
at the back of this
manual.)
● Operation curve setting
(For a description of the
setting method, see the
description at the back of
this manual.)
Fine tuning trim
setting
The on time (start/stop
time) can be set up to 4
seconds. It is useful for
landing gear control of the
jet or scale plane, etc.