FUTABA T16IZ SUPER Full Manual page 158

Acceleration
setting. The setting method is the same.
to camber mixing. Setting is not performed when Ele to
camber mixing is INH.
side and down side.
menu and call the setup screen shown
below.
When using this
function, Tap [INH].
(ON is displayed.)
The rate the angle
increases.
can be set.
and deceleration can be set. When an
operation point is exceeded, acceleration is
performed.
[Corresponding model type]: Airplane/glider general
Condition group/
single mode selection
(Gr. /Sngl)
The return time after operation (Damping)
can be set.
（First return）1 〜 100（Slow return）
（Acceleration doesn't function as 0.）
To next page
2/3 : Elevator → Camber
3/3 : Aileron → Rudder
Note: When using the acceleration function,
since the servo stroke is large, make your
settings so there is no binding of your linkage.
158
Operation up to this
range will initiate
acceleration.
Act position
Current position