FUTABA T16IZ SUPER Full Manual page 180

screen.
The Hovering Pitch trim function trims the pitch
the hovering condition. The hovering pitch can be
rotor speed is constant. This function can be used
for more delicate operation.
condition, switch the group mode to the
single mode (initial setting) before setting.
Selection example: LD
Normal) can be selected.
Center mode: Maximum amount of change
n e a r c e n t e r b y c e n t e r t r i m o p e r a t i o n
(recommended)
N o r m a l m o d e : N o r m a l t r i m ( p a r a l l e l
movement trim) operation. The advantage
of using this mode is that the hovering pitch
can be adjusted without changing the
curve.
When this value is made small, trim can only
be used near the center.
operation direction can be changed.
Hovering pitch trim
setting
180
Low/high pitch trim
setting
to all the conditions, set them in the group
mode.
Selection example: LS (high side), RS (low
side)
operation direction can be changed.
center as the standard.