Polaris RZR XP Turbo Service Manual page 303

6. Remove the four fasteners
shaft to the transmission coupler. Discard the
fasteners. Move the prop shaft off the coupler
towards the outside of the vehicle.
IMPORTANT
The coupler fasteners have patch lock on the threads
and must be replaced any time they are removed.
7. Mark the front and rear prop shaft for reassembly.
NOTE
The prop shafts have a master spline and will only go
on one way.
9928491 R04 - 2017-2018 RZR XP Turbo / XP4 Turbo Service Manual
© Copyright Polaris Industries Inc.
y
retaining the rear prop 8. From under the vehicle, disengage the rear prop shaft
from the front prop shaft and remove the rear prop
shaft out the bottom of the vehicle.
NOTE
Move the front prop shaft as far towards the front of the
vehicle as possible to allow the rear prop shaft yoke to
disengage from the splines on the front prop shaft.
9. For front prop shaft removal, pull the bearing isolator
towards the rear of the vehicle to disengage it from
the prop shaft.
NOTE
The front prop shaft cannot be removed with the
isolator installed.
FINAL DRIVE
7
7.23