Hazard Switch (Int'l / Tractor); Turn/Lights/Horn Switch (Int'l/Tractor); Horn; Turn Lights - Polaris RZR XP Turbo Service Manual

ELECTRICAL

HAZARD SWITCH (INT'L / TRACTOR)

Testing
1. Disconnect the harness from the hazard switch.
2. Test outputs in both the ON and OFF positions. If any
of the tests fail, replace the switch.
• Move switch to ON. There should be continuity
between switch pins 2 and 3.
• Move the switch to OFF. There should be no continuity
between any switch pins.
TURN/LIGHTS/HORN SWITCH (INT'L/
TRACTOR)
Testing
1. Disconnect the Turn/Lights/Horn
depressing the connector locks and pulling on the
connector. Do NOT pull on the wiring.
2. Test between the sets of outputs. If any of the tests
fail, replace the switch assembly.
• Turn on the High Beam. There should be continuity
between switch pins 2 and 5.
• Turn on the Low Beam. There should be continuity
between switch pins 2 and 6.
• Turn on the Left Turn Signal. There should be
continuity between switch pins 1 and 8.
11.28
• Turn on the Right Turn Signal. There should be
continuity between switch pins 1 and 7.
• Depress the Horn. There should be continuity between
switch pins 3 and 4.

HORN

The horn
radiator, accessible through the front left side of the
vehicle.
switch by

TURN LIGHTS

Front
The front turn lights are retained to the front bumper by a
single faster
9928491 R04 - 2017-2018 RZR XP Turbo / XP4 Turbo Service Manual
q
is located in the front of the unit behind the
q
, accessible through the front grill.
© Copyright Polaris Industries Inc.